NOTE- RYONET CHANGED OVER FOIL MANUFACTURERS SO TIME AND TEMPERATURE SETTINGS SHOWN IN VIDEO ARE INACCURATE- BELOW ARE THE CORRECT SETTINGS. THE PROCESS, ASIDE FROM THOSE SETTINGS, IS THE EXACT SAME.
Foil is applied colored side up and aluminum looking (dull) side down. Rub foil with eraser immediately after application to help remove any wrinkles. Allow transfer to cool completely (20 to 30 seconds) after application before removal of foil sheet. Pull foil sheet off slowly. It can be helpful to tint the 3801LF Foil Adhesive, to the color of the foil being applied, with a small amount of conventional plastisol. This process will help to keep small pinholes in the applied foil film from being noticeable. As example: Use a few grams of yellow or gold plastisol in the 3801LF Adhesive when using gold foil. Use a few grams of black or gray plastisol in the 3801LF Adhesive when using silver foil.
280F to 375F (138C to 190C). Try lower temperature first for best results.
T-Shirts = Medium (35lbs)
Sweatshirts = Medium to Heavy (35lbs to 60lbs)
The brightest foil effect will result when the foil is first removed. To achieve a textured matte finish foil, re-seal the garment or hat in the transfer press for 3-4 seconds after the foil carrier film has been removed.
For best durability of the foil after it is applied, it is recommended that the garment be hand washed or machine washed (delicate cycle) inside out and line or air dried. Do not use bleach. Do not iron printed area.