Step 1: Stabilize press by drilling into table/surface.
Step 2: Put the pedestal on. Use hex key to tighten bearings to center post.
Step 3: Attach stabilizing arm. Each arm has quantity 2, 1 / 4 inch silver bolts. Use a 7/16th wrench to tighten down. All L’s should be facing the left.
Step 4: attach color arm. GOLD BOLTS. 5/16 flat washer, 5/16 lockwashers, 5/16 Fine thread bolts. Use ½ inch ratcheting wrench.
Need a ½ inch wrench
Step 1: Slide centering hub into the two side arms. Flip upside down and align holes by eye.
Step 2: Slide in shim plate (has to go in the bottom, not the top).
Step 3: Put in bolts with the Alan Wrench side down, then a washer and a nut. Hand tighten.
Step 4: Flip over and hammer in locator pins.
Step 5: Take Alan Wrench and tighten nuts and bolts.
Step 6: Put arms over base post.
Step 7: Put on bottom spacer.
Step 8: Proceed to head assembly.
Step 1: Remove current clamp head. Set off to side for hardware.
Step 2: Flip over new micro and remove the hardware for new off contact brackets: 4 and ½ inch bolt (with 2 washers and nut) and One Wrench Clip (crush tube) (with 1 washer and nut). Remove screw, washer and nut that attach both L brackets as well.
Step 3: Install L Brackets. Start with the large hole, 4 and ½ inch bolt and washer, use washer and regular nut (on other side) and then hand snug tight. Install One Wrench clip with washer, then crush tube and nut.
Step 4: Install micro. Slide over brackets and use supplied 3/4th inch carriage bolts to attach. Use 1 washer and regular nut. (repeat for other side).
Step 5: Remove old off contact brackets from clamp head. Hammer out the carriage bolts.
Step 6: Attach clamp head to micro. Use 3/4th inch carriage bolt. Put these into clamp head prior to attaching and seat bolt by tightening a nut all the way down and then removing it. Attach clamp to the micro. No washers required, use Flange Nuts.
Loosen screen clamp assist knobs, then loosen locking knobs. Adjust reg, then tighten lock knobs back and forth until snug. Then tighten screen clamp support knobs until snug.