Silver Press Assembly (The New Dis-assembled Press) VIDEO

Follow

Comments

6 comments

  • Avatar
    arthur brinson

    im having issues I get perfect registration on initial set up (first print) then after a couple prints my image walks side to side I tested this by printing one pass then flash then print again movement im doing something wrong from press assembly to print mechanics should I reset up press assembly and make sure everything is the same or are my my wood frames may be the cause

  • Avatar
    Lainey

    Hello Arthur, do you have your screens all the way back and flush in the screen clamp?

  • Avatar
    arthur brinson
    I dont think so as i was making sure all 4 heads off contact was the same i noticed that when i put the screens in flush to the back they sat at a very bad angle to the palate so set my off contact up that way just like in the video i have yet to try it
  • Avatar
    arthur brinson
    I think ive been setting my screens up to the palate
  • Avatar
    arthur brinson
    And not making sure they were flush in the clamp
  • Avatar
    Lainey

    Hi Arthur,

    You need to make sure the screen is all the way back and flush in the clamp or else the clamp head doesn't have enough leverage on the screen to keep it in place.  Before burning the screens, make sure you're measuring out where the films are on the screens so that they are in the same spot on each screen.

Please sign in to leave a comment.